Advertisement
is not suitable for the higher speed of a smaller
tool and may burst.
Additional Safety Warnings:
17. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
18. Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
19. Use the specified surface of the wheel to
perform the grinding.
20. Watch out for flying sparks. Hold the tool so
that sparks fly away from you and other
persons or flammable materials.
21. Do not leave the tool running. Operate the tool
only when hand-held.
22. Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
23. Always be sure that the tool is switched off
and unplugged or that the battery cartridge is
removed before carrying out any work on the
tool.
24. Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
25. Check
that
supported.
26. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure
operator safety.
27. Do not use the tool on any materials
containing asbestos.
28. This tool has not been waterproofed, so do
not use water on the workpiece surface.
29. Ensure that ventilation openings are kept
clear when working in dusty conditions. If it
should become necessary to clear dust, first
disconnect the tool from the mains supply
(use
non
metallic
damaging internal parts.
30. Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
the
workpiece
is
objects)
and
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
013342
CAUTION:
Before plugging in the tool, always check to see
•
the switch trigger actuates properly and returns to
the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger and then push in the lock button.
To stop the tool from the locked position, pull the switch
properly
trigger fully then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing grinding wheel
CAUTION:
Overtightening the wheel can cause breakage.
•
Failure to tighten sufficiently will cause flutter.
avoid
013346
5
1. Switch trigger
2. Lock button
1
2
1. Inner flange
1
2. Hex nut
2
Advertisement
