Configuring Gmpls Uni Controller As A Tunnel Head - Cisco CRS Configuration Manual

Implementing GMPLS UNI
Command or Action
Step 5
Use the commit or end command.

Configuring GMPLS UNI Controller as a Tunnel Head

Perform this task to configure the tunnel properties for a GMPLS UNI controller.
This configuration designates the controller as a tunnel-head, rather than a tunnel tail. After the tunnel properties
are configured, the incoming path messages are rejected and any existing tail-end tunnel is torn down.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. gmpls optical-uni
4. controller dwdm interface
5. tunnel-properties
6. tunnel-id number
7. destination ipv4 unicast address
8. path-option 10 no-ero lockdown
9. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Purpose
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring TE for GMPLS UNI
377