Configuring The Automatic Bandwidth Functions - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action
Step 3
show mpls traffic-eng tunnels [auto-bw]
Example:
RP/0/RP0/CPU0:router# show mpls
traffic-eng tunnels auto-bw
Related Topics
Restrictions for MPLS-TE Automatic Bandwidth, on page 193

Configuring the Automatic Bandwidth Functions

Perform this task to configure the following automatic bandwidth functions:
Application frequency
Bandwidth collection
Bandwidth parameters
Adjustment threshold
Overflow detection
Configures the application frequency in which a tunnel bandwidth is updated by the automatic bandwidth.
Configures only the bandwidth collection.
Configures the minimum and maximum automatic bandwidth to set on a tunnel.
Configures the adjustment threshold for each tunnel.
Configures the overflow detection for each tunnel.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Purpose
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without committing
the configuration changes.
Displays information about MPLS-TE tunnels for the automatic bandwidth.
Configuring the Automatic Bandwidth
291