Service Information; Specifications; Maintenance - Black & Decker CE750 Linea Pro Instruction Manual

Hand planer

Hide thumbs

Table Of Contents

Table of Contents

Available languages

To Reinstall Blade

a. Slide the blade sideways into the holder until it is against

the end stop. Blade groove must be toward back of unit.

b. Securely tighten the three nuts using the wrench supplied.

c. Rotate the blade drum 180˚ degrees and repeat for other

blade.

d. Always replace both blades.

PARKING FOOT (Fig. L)

Your planer is equipped with a parking foot (15) that

automatically lowers into place when the tool is lifted from the

work surface. When planing, the parking foot raises as the tool

is pushed forward. When the parking foot is lowered, the

planer can set on the work surface without the blade touching.

Caution! Do not lock the trigger switch on and engage the

parking foot. The vibration of the running motor will cause the

planer to move, possibly falling from the work piece.

EDGE CHAMFERING (Fig. M)

Your planer has three precision machined chamfering grooves

1.5mm, 2.0mm and 2.5mm (16). They are located in the front

shoe and are used for planing along a corner of the material

(Fig. M).

a. Adjust to desired depth of cut.

b. Place groove (16) over edge of material.

c. Apply weight to front of shoe so groove is flat on material

edge.

d. Hold tool with both hands keeping pressure on front handle.

Note: It s a good idea to try a piece of scrap wood

before doing finish work.

DRIVE BELT (Fig. N)

Warning! Turn off and unplug the tool before making any

adjustments or removing or installing accessories.

To Replace Belt

a. Loosen the three screws shown in Fig. N and remove the

belt cover.

b. Remove old belt.

c. Place new belt over front pulley then rotate belt clockwise

while pushing belt onto back pulley.

d. Attach belt cover and securely tighten screws.

MAINTENANCE

Your tool has been designed to operate over a long period

of time with a minimum of maintenance. Continuous satisfactory

operation depends upon proper tool care and regular cleaning.

Warning! Before performing any maintenance, switch off

and unplug the tool.

Cleaning

► Turn off and unplug unit before cleaning chip discharge

chute. Clean the chip discharge chute (6) regularly.

Always wear safety glasses.

► Never use solvents or other harsh chemicals for cleaning

the non-metallic parts of the tool. Use only mild soap and

damp cloth to clean the tool. Never let any liquid get

inside the tool; never immerse any part of the tool into

a liquid.