Philips VideoPlus+ DVDR990 Instructions For Use Manual page 51

The recorder does not record
timer programme
No new title can be recorded
Service codes on the display
'Disc warning' message on screen
'Disc error' message on screen
Disc errors
Two languages are 'mixed' when
recording from a stereo VCR
The disc cannot be erased because the
Index Picture Screen does not appear
The Index Picture Screen does not appear
but the titles on the disc can still be played Choose 'Adapt to own disc format' (See 'User Preferences - Features).
A DVD player shows the Index Picture
Screen but does not react to
the 2 PLAY key
Downloaded From Disc-Player.com Philips Manuals
• Make sure that the recorder is switched to standby before the timer
starts.
• Check if the maximum number of titles has been reached (message:
'too many titles' on screen). If so, delete a title next to a free space.
• Check if the disc is write protected. If so, unlock the disc in the disc
settings menu (message: 'Disc locked' on screen).
• Check if the (DVD+R) disc has been finalized. If so, no new titles can
be recorded anymore.
• Clean the disc. The recording was most probably done correctly.
• A write error has occured, but it could be corrected. No user action
is required.
• A write error has occured from which the recorder could not
recover. Inspect the disc and clean it if necessary (refer to 'Intoduction -
Cleaning discs' for cleaning instruction). Record (overwrite) again over
the same part of the disc to see if the problem is solved
• A disc might be corrupted because of dust, scratches or fingerprints.
If the disc cannot be accessed anymore, use the back-up disc erase
procedure to repair it. Proceed as follows:
1. Clean the disc.
2. Put disc in the drawer (do not close the tray).
3. Press and hold CLEAR for several seconds until the tray closes.
• When the TV set does not automatically detect the dual-language
signal,use left/right audio balance on the TV set to amplify the one or
the other language.
1. Open the tray while leaving the disc in.
2. Hold CLEAR pressed for around 5 seconds until the tray closes. The
disc is technically not yet erased but you can start a new recording like
on a blank disc.
• Take out the disc. Clear the disc. Insert the disc.
• Press 9 STOP to exit the Index Picture Screen, then press 2 PLAY.