Installing The Water Dispenser Line; Connecting To The Water Supply Line; Parts For Water Line Installation - Samsung SRF679SWLS User Manual

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
In order for the ice maker to operate properly, a
water pressure of 138 ~ 862 kPa is required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until
the water runs from the water outlet.
Water line installation kits are include with
unit. You can find it in freezer drawer.
The new hose-sets supplied with the
appliance are to be used and that old
hose-sets should not be reused.

Parts for water line Installation

Water line fixer and screws
Water line
DA68-03022B (EN)-04.indd 25

Connecting to the water supply line

1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
The water line must be connected to the
cold water pipe.
If it is connected to the hot water pipe, it
may cause the purifier to malfunction.
Close Main Water
4. After connecting the water supply to the water
filter, turn your main water supply back on and
dispense about 3 L to clear and prime the
water filter.
Pipe connector
English - 25
CAUTION
pipe
Close Main
No gap
Water pipe
14. 6. 23. 2:47