Adjustment Of Hole Punch Unit - Toshiba e-studio600 Service Manual

3.14 Adjustment of Hole punch unit

3.14.1 Sensor output adjustment
Perform this adjustment when the punch driver PCB, transmission sensor (photosensor PCB/LED
PCB) or reflection sensor (scrap full detection PCB unit) has been replaced.
(1) Remove the rear cover of the finisher unit.
(2) Set bits 1 through 6 of DIPSW3 on the finisher controller PCB as indicated.
(3) Press SW1 on finisher controller PCB. Pressing this switch automatically adjusts sensor output.
(4) Set all bits on DIPSW3 to OFF
March 2005 © TOSHIBA TEC
ON
1 2 3 4 5 6 7
Fig.3-89
3 - 77
8
e-STUDIO520/600/720/850 ADJUSTMENT
3