Shock Absorber Spring Preload Adjustment - Husqvarna 2011 TE 630 Workshop Manual

Shock absorber spring preload adjustment

Proceed as follows:
1. Insert the key in latch (1) then turn clockwise to release the saddle lock;
remove the saddle.
2- Disengage rear left-hand side panel (2) then slide it toward vehicle front.
3. Clean lock ring nut (3) and adjuster ring nut (4) of the spring (5).
4. Either with a hook wrench or an aluminium punch, loosen the lock ring nut.
5. Turn the adjuster ring nut as required.
6. Adjust preload to suit your weight or riding style and tighten the lock ring nut
firmly (tightening torque 50 Nm - 5 Kgm - 67.8 ft/lb).
7. Reassemble the L.H. side panel and the saddle.
Be careful not to touch hot exhaust pipe while adjusting the shock absor-
ber.
Part. N. 8000 H2051 (02-2010)
SETTINGS AND ADJUSTMENTS
D.25
4