Advertisement
Quick Links
WCR-G54 Router Access Point Settings
1.
At the back of router, set the switch to "Router" mode
2.
Power on Buffalo Router, and wait for 2 minutes.
The "Power", "Router" and "Wireless" indicators will be ON, and other
indicators will be OFF.
3.
To reset the router, please insert "RESET" hole by a paper clip for about
10 seconds, and wait for 2 minutes.
The "Power", "Router" and "Wireless" indicators will be ON, and other
indicators will be OFF.
Last Update 24April 2008
4.
Please use network cable to connect "LAN1" port on the ROUTER to
the Ethernet adapter on your PC. Make sure indicator besides "LAN1" is
ON.
WCR-G54 Access Point Page 1
Advertisement
Related Manuals for Buffalo WCR-G54
Summary of Contents for Buffalo WCR-G54
- Page 1 At the back of router, set the switch to “Router” mode the Ethernet adapter on your PC. Make sure indicator besides “LAN1” is Power on Buffalo Router, and wait for 2 minutes. The “Power”, “Router” and “Wireless” indicators will be ON, and other indicators will be OFF.
- Page 2 WCR-G54 Router Access Point Settings Buffalo Router Wireless Settings: Please click “Apply” again, and wait for 2 minute to complete settings. Launch Web Browser, enter http://192.168.11.1 in address bar and then press Enter. Then type username as “root”, default no password.
- Page 3 2. At the back of router, set the switch to “Bridge” mode 3. The “Router” indicator will be OFF. 4. Connect “LAN 1” port of Buffalo router to your existing network. Settings Complete. Last Update 24April 2008 WCR-G54 Access Point Page 3...