D-Link AirPremier DWL-G680 Manual page 16

Using the Configuration Utility (continued)
Frequency:
Select the Frequency
Starting Ad-Hoc Network:
Select the Ad-Hoc Network
Ad-Hoc Channel:
All devices in the Ad-Hoc network must be set to the same channel
Profile IP Settings:
You can Enable or Disable
the IP Settings portion of your
profile here. If you select
Disable you will need to
configure the IP Address
information each time you
connect to a network. If you
select Enable you will
maintain the same IP Address
information each time you
connect to a network.
Power Mode:
Disable -this default setting
consumes the most power
Enable - this setting
consumes the least power.
Launch Utility on Startup:
Select Enable or Disable
Data Packet Parameter:
Set the Fragmentation Threshold and the RTS Threshold. Please see below.
Fragmentation Threshold:
This value should remain at its default setting of 2432. If you experience a high packet
error rate, you may slightly increase your Fragmentation Threshold within the value
range of 256 to 2432. Setting the Fragmentation Threshold too low may result in poor
performance.
RTS Threshold:
This value should remain at its default setting of 2432. If inconsistent data flow is a
problem, only a minor modification should be made.
Click Apply if you have made any changes
Advanced
16