Connecting Wires To Terminals - Kenwood KDC-5021V Instruction Manual

Connecting Wires to Terminals

11 Rear right output (Red) /
10 Non-fading right output (Red)
(KDC-MV6521/M6021/6021 only)
12 Rear left output (White)/
10 Non-fading lleft output (White)
(KDC-MV6521/M6021/6021 only)
13 Front right output (Red)
14 Front left output (White)
Antenna Cord (ISO) 3
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
To External Display/ Steering remote
(KDC-MV6521/M6021/6021
FM/AM
antenna input 2
1
only)30
Fuse(10A)
4
To KENWOOD disc changer/
DAB control input/
KPA-SD100/KPA-HD100/KPA-SS100
To connect these leads, refer
to the relevant instruction
manuals. 17
Battery wire (Yellow)
Ignition wire (Red)
A–7 Pin (Red) 8
A–4 Pin (Yellow) 9
Connector A
Connector B
Pin Numbers for
ISO Connectors
External Power
Connector
Speaker
Connector
Wiring harness
(Accessory1)
5
16
TEL mute wire (Brown)
6
7
Power control/ Motor antenna
control wire (Blue/White)
8 6 4 2
7 5 3 1
If no connections are made, do not let the
8 6 4 2
cable come out from the tab.
7 5 3 1
— 31 —
Connector Function Guide
Cable Colour
A–4 Yellow Battery
A–5 Blue/White Power Control
A–6 Orange/White Dimmer
(KDC-MV6521/M6021/6021 only)
A–7 Red Ignition (ACC)
A–8 Black Earth (Ground)
Connection
B–1 Purple Rear Right (
B–2 Purple/Black Rear Right (
B–3 Gray Front Right (
B–4 Gray/Black Front Right (
B–5 White Front Left (
B–6 White/Black Front Left (
B–7 Green Rear Left (
B–8 Green/Black Rear Left (
21
Connect to the terminal that is
TEL MUTE
grounded when either the telephone
rings or during conversation.
To connect the KENWOOD
navigation system, consult your
navigation manual.
22
Connect either to the power control
P.CONT
terminal when using the optional
ANT.CONT.
power amplifier, or to the antenna
control terminal in the vehicle.
27
Functions
+
)
–
)
+
)
–
)
+
)
–
)
+
)
–
)
24
25
26