Touch Sensor Tone; Manual Clock Adjustment; Synchronize Clock; Dsi (Disabled System Indicator) - Kenwood KDC-5021V Instruction Manual

Press the Reset button and when it's removed from the
battery power source
1
Turn the power ON.
2
Do the step 4 through 7 step operation, and reenter the
security code.
"APPROVED" is displayed.
The unit can be used.
If an incorrect code is input, "WAITING" is displayed, and the input
prohibited time shown below is generated.
After the input prohibited time lapses, "CODE" is displayed, and
input can be done.
Number of times
the incorrect code was input
1
2
3
4

Touch Sensor Tone

Setting the operation check sound (beep sound) ON/OFF.
Display
"Beep ON"/ "BEEP ON"
"Beep OFF"/ "BEEP OFF"

Manual Clock Adjustment

This adjustment can be done when the <Synchronize Clock> (page
25) is set as OFF.
1
Select Clock Adjustment mode
Press the [FM] or [AM] button.
Select the "CLK ADJ" display.
Input prohibited time
—
5 minutes
1 hour
24 hours
Setting
Beep is heard.
Beep canceled.
— 25 —
2
Enter Clock Adjust mode
Press the [4] or [¢] button for at least 1 second.
The clock display blinks.
3
Adjust the hours
Press the [FM] or [AM] button.
Adjust the minutes
Press the [4] or [¢] button.
4
Exit Clock adjustment mode
Press the [MENU] button.

Synchronize Clock

Synchronizing the RDS station time data and this unit's clock.
Display
"SYNC ON"
"SYNC OFF"
It takes 3 to 4 minutes to synchronize the clock.

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the faceplate is
removed, warning potential thieves.
Display
"DSI ON"
"DSI OFF"
Setting
Synchronizes the time.
Adjust the time manually.
Setting
LED flashes.
LED OFF.