Clutch Discs Replacement (Tc-Te-Txc-Smr) - Husqvarna TC 450 Workshop Manual

SETTINGS AND ADJUSTMENTS

Clutch discs replacement (TC-TE-TXC-SMR)

This operation can be carried out by laying the motorcycle on the left side without
draining the engine oil. Remove the five fastening screws (1) and the clutch
1
cover (if necessary, lower the rear brake control pedal). Use a 5 mm allen wrench
to loosen the six screws (2) that fasten clutch springs. Remove springs, pressure
plate (3) complete with bearing and clutch control rod (4). Extract the discs (5),
lubricate the new discs with engine oil then assemble the new discs (first always
mount a lined disc). Reassemble pressure plate and springs. Tighten the clutch
springs bolts whilst following a cross-over pattern and in steps (8 Nm-0,8 Kgm-
5.8 ft/lb). Reassemble the clutch cover (8 Nm-0,8 Kgm- 5.8 ft/lb).
D.10 Part. N. 8000 H1344 (10-2009)