NEC Xen IPK Installation Manual page 63

Xen IPK Xen Mail CTI Installation Guide
Backing Up & Restoring the System
To transfer backup files to a support computer
1 Establish a remote access connection. See "To establish a remote
access connection," on page 33 for details.
2 At an OS/2 command prompt, go to the E:\Vmail directory.
3 For a direct connection, type brfthost -d and press ENTER.
For a modem connection, type brfthost -bn -m and press ENTER,
where n represents the baud rate. For example, type
rate of 9600.
4 During the file transfer, a message with the connection type and baud
displays on the screen.
To cancel the file transfer on the host computer, press
NOTE:
CTRL+BREAK.
5 End the connection and exit Windows Remote.
6 Go to the directory where you installed the BRFT Remote software and
double-click on the Brftrmt.exe file to start the program.
7 From the BRFT Connection menu, type 3 and press ENTER to select
"Configure serial ports."
8 From the Serial Port Configuration menu, select one of the following:
• 1 and press ENTER for "Select serial port."
• 2 and press ENTER for "Change baud rate."
These settings must match the host's BRFT serial port settings.
NOTE:
9 To save the new serial port settings for future BRFT connections, type 3
to save the settings. Otherwise, these settings are only valid for this
connection.
10 Type 4 to return to the BRFT Connection menu.
After 2 minutes of inactivity, the host utility will end the connec-
NOTE:
tion.
11 From the BRFT Connection menu, type 1 for a modem connection or
type 2 for a direct connection.
12 If asked, type the voice messaging system's phone number and press
ENTER.
13 Follow the on-screen instructions until the main menu appears.
14 When the main menu appears, type 1 to transfer backup files.
15 Follow the on-screen instructions to complete the backup and exit the
BRFT Remote software.
for a baud
-b9600
Chapter 4 - 57