Kenmore 790.4802 Use And Care Manual page 8

Setting the Oven Controls
Setting the Clock
The _'_ pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted,
the timer in the display will flash (See Fig. 1).
INSTRUCTIONS PRESS
To set the clock (example below for 1:30)
1. Press _. "CLO" will appear in the display (Fig. 2).
2 Press _ (Z) @ pads toset t he time o fday t o1:30/Fig
3). Press _.ARj_. "CLO" will disappear and the clock will start
(Fig. 4).
Q
OQ@
Changing between 12 or 24 hour time of day display
1. Press and hold _ for 7 seconds until "12h" or "24h"
appears in the display.
2. Press @ to switch between the 12 and 24 hour time of day
display. "12h" (Fig. 5) or "24h" (Fig. 6) will be displayed.
3. Press _ART"_to accept the change or press (_ to reject the
change.
4. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode was
chosen, the clock will now display time from 0:00 through
23:59 hours.
Q
for 7 seconds
@
(_or
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Setting Silent Control Operation
The DELAYTIME @ and FLEX CLEAN @ pads control the Silent Control operation feature, The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the
control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps,
INSTRUCTIONS
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent operation press
and hold @
for 7 seconds (Fig. 7).
2. Press @ to switch between normal sound operation and
silent operation mode. The display will show either "SP" (Fig.
8) or "--" (Fig. 9).
If "SP" appears (Fig. 8), the control will operate with normal
sounds and beeps. If % -" appears (Fig. 9), the control is in the
silent operation mode.
3. Press _ to accept the change or press _
to reject the
change.
PRESS DISPLAY
@
for 7 seconds Fig. 7
@
Fig. 8
Fig. 9