Functional Description - Makita BO5030 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
009101
CAUTION:
Before plugging in the tool, always be sure that the
•
tool is switched off.
To start the tool, press the "I (ON)" side of the switch. To
stop, press the "O (OFF)" side of the switch.
Speed adjusting dial
For BO5031 only
009439
The tool speed can be infinitely adjusted between 4,000
and 12,000 orbit per minute by turning the adjusting dial.
Higher speed is obtained when the dial is turned in the
direction of number 5; lower speed is obtained when it is
turned in the direction of number 1.
Refer to the figure for the relationship between the
number settings on the adjusting dial and the kind of
work.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
1. Switch
1
1. Speed adjusting
dial
1
12000
4000
A
1 2
Dial setting
003291
NOTE:
The figure shows standard applications. They may
•
differ under certain conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing abrasive disc
009102
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then peel off the backing paper
from the abrasive disc and attach the abrasive disc to
the pad. Be careful to align the holes in the abrasive disc
with those in the pad.
CAUTION:
If you peel off the abrasive disc from the pad, its
•
adhesion will become poor. Never attempt to stick
it onto the pad for further use.
Installing dust bag
009104
5
C
B
3 4 5
1. Dust bag
1