Advertisement
Date: 12/28/07
Parts& RepaLr S ervices
SF22-804
Page
4 of 6
7. Install the resistor on the rear wall as
shown in the photo. Carefully
punch or
drill a starter hole for the screw if
necessary.
8. Use existing screw holes to install the
new 120 ° thermostat
to the left of the
existing
170 ° thermostat.
Mark the
chassis with an "X "or "120" to identify
the new thermostat.
9. Install wire # 1 (318052584)
onto the
"C" terminal of the new switch. This
wire has a push on terminal on one
end and is stripped on the other end.
10. Disconnect
the power wire from the
170 ° thermostat,
cut off the terminal
connector
and strip approx. 3/16 inch
of the insulation.
The power wire is
the one that does not connect to the
fan motor.
(318052584
From Kit
Confidential
Information
-For
Internal Use Only
DEPARTMENT
702HSX - Leo Steinys
DEPARTMENT
702PSO
- Bob Vondale
Advertisement
