Removing The Chassis Cover; Removing The Compact Flash Memory Card - Cisco 2600 Series Hardware Installation Manual

Appendix B Maintaining the Router
Compact Flash Memory Card Installation and Removal
To remove or install a compact Flash memory card mounted internally on the router, perform the
procedures described in this section.

Removing the Chassis Cover

See the
the Cisco 2691 chassis cover. This section describes how to remove the chassis cover to access the
compact Flash memory card.

Removing the Compact Flash Memory Card

After removing the chassis cover, complete the following steps to remove the compact Flash memory
card from the router:
Step 1 Locate the compact Flash memory card on the system board. (See
Figure B-12 Compact Flash Memory Card Location in a Cisco 2691
Remove the retention screw that retains the compact Flash memory card by using the Phillips
Step 2
screwdriver; save the retention screw for reinstallation.
Carefully pull the compact Flash memory card free from the connector.
Step 3
Place the removed compact Flash memory card on an antistatic surface or in a static shielding bag.
Step 4
OL-2171-02
"Removing the Chassis Cover on Cisco 2691" section on page B4
Compact Flash
memory card
Retention screw
Installing and Formatting Compact Flash Memory Cards in Cisco 2691 Routers
Cisco 2600 Series Routers Hardware Installation Guide
for instructions on removing
Figure B-12.)
B-19