Cisco 2600 Series Hardware Installation Manual page 77

Appendix B Maintaining the Router
Make sure the new DIMM is the correct type, EDO or SDRAM, for your router. (See
Note
Figure B-6
A
B
3
Insert the new DRAM DIMM by sliding the end with the metal fingers into the DIMM connector socket
Step 7
at approximately a 90º angle to the system card. Gently rock the DIMM back into place until the latch
on either side snaps into place. See steps 3 and 4 of part B in
because the connector might break.
Replace the router cover. Follow the instructions in the
Step 8
OL-2171-02
Removing and Replacing the 100-Pin DRAM DIMM
2
1
4
1
3
Figure B-6. Do not use excessive force
"Closing the Chassis" section on page
Cisco 2600 Series Routers Hardware Installation Guide
Upgrading DRAM
Table B-1.)
B34.
B-9