Advertisement
6
Mounting Options
Whichever mounting option is chosen should be approved by a local Professional Engineer (PE). All of
the options listed have been rated by our Professional Engineer and certified for WindTronics. Please
refer to the following designs and their included specifications.
Quick Start: DC Charge Controller for Honeywell Wind Turbine WT6500 - Rev 1.0 - 28Sep11
PERSONAL INJURY AND PROPERTY DAMAGE HAZARD
Do not install the Honeywell Wind Turbine in a location that is accessible to
children or pets. Failure to follow this warning may result in death, personal
injury or property damage.
PERSONAL INJURY AND PROPERTY DAMAGE HAZARD
The Honeywell Wind Turbine must be mounted by WindTronics Authorized
Installers or other licensed contractors only, with the use of all appropriate
hardware. Failure to follow this warning may result in death, personal injury
or property damage.
Failure to follow proper installation practices for any of the mounting options
could result in death, serious injury and/or property damage.
WHEN MOUNTING ON OR OVER A COMBUSTIBLE SURFACE, A FOOT
PLATE OF AT LEAST 1.43 mm GALVANIZED OR 1.6 mm UNCOATED
STEEL EXTENDED AT LEAST 150 mm BEYOND THE EQUIPMENT ON
ALL SIDES MUST BE INSTALLED.
Power shall be disconnected from the equipment before the DCCC junc-
tion box enclosure is opened and the enclosure shall be closed before the
power is restored. Failure to do so may result in death, serious injury and/or
property damage.
If any maintenance is to be done on the turbine, the turbine must be put in
STOP mode, the turbine switch on the DCCC junction box must be in the
"Turbine Off" position and the wheel must be tie wrapped to prevent turning.
Failure to do so may result in death, serious injury and/or property damage.
Use of WindTronics' products for other than their intended purpose may
void warranty.
Quick Start
Advertisement
