Advertisement
Driving operation (Fig. 14)
Switch on the tool by pressing the trigger
and a t the same time pushing the lock
button. Hold the tool squarely against the
workpiece and apply forward pressure to
the tool. The screw will be automatically
carried to the driving position and driven
into the workpiece.
Fig.
14
IMP0 RTANT :
Do not fire the tool without screws. This will damage the workpiece.
0
If the feeder box becomes sluggish in operation, spray car wax (spray type wax) on i t s
sliding surfaces. Never lubricate it.
Installing or removing the bit (Fig. 15 & 16)
CAUTION :
Always be sure that the tool is switched off and unplugged before installing or removing
the bit.
Loosen the bolt which secures
the
casing. Pull out the casing in the direction of the
arrow. Press the dust cover toward the plane bearing and pull out the bit. I f the dust
cover cannot be moved
as
far as the plane bearing, try
it
again after turning the bit
slightly.
To install the bit, insert it into the socket while turning
it
slightly. After installing, always
make sure that the bit is securely held in place by trying to pull
it
out.
Fig.
l !
Plane bearing
- ,
Fig.
16
10
Advertisement
