Table of Contents
Advertisement
OSD Menu
Cursor Down
Cursor Up
Decrease Adjustment
To turn on the monitor, press the power button on the front panel. After a few
seconds, video should appear on the monitor. If video does not appear, refer to
the
Troubleshooting
Pressing the
Under Scan
Scan". When the monitor is set to "Under Scan", the LED is lit and the entire
picture, with some black border, is displayed on the monitor. In "Over Scan", the
picture fills the screen.
Pressing the
Video Input
and
B
LEDs light indicating which video source is displayed on the monitor.
Pressing
Menu
brings up the OSD (on-screen display) menu. The
cursor are used to move between items in the menu. The
are used to make adjustments to individual menu items.
The OSD menu options are :
Volume :
Adjusts the audio volume
Contrast :
Adjusts the image contrast
Brightness :
Adjusts the image brightness
Sharpness :
Adjusts the image sharpness
Color
: Adjusts the image color intensity
NOTE :
When the monitor is in the PAL mode, Tint is not on the menu.
Tint :
Adjust the image color. For best results, adjust for natural skin tones.
H-Position :
Adjusts the horizontal position of the image on the screen.
V-Position :
Adjusts the vertical position of the image on the screen.
CHAPTER 3:
OPERATION
Figure 7 - Front panel controls
section of this manual.
button switches between "Over Scan" and "Under
button switches between two video sources. The
12
Power
Under Scan
Video Input
Increase Adjustment
Up
Left
and
Right
A
and
Down
cursor
Advertisement
Table of Contents
