Propeller Shaft Housing (Ft50, Ft60); Removing The Propeller Shaft Housing Assembly; Disassembling The Propeller Shaft Assembly; Disassembling The Propeller Shaft Housing - Yamaha F50F Service Manual

Removing the propeller shaft
housing assembly
1. Straighten the claw washer tabs a, and
then remove the ring nut and claw
washer.
Ring nut wrench 3 1: 90890-06511
Ring nut wrench extension 2:
90890-06513
2. Pull out the propeller shaft housing
assembly.
Bearing housing puller claw L 3:
90890-06502
Stopper guide plate 4: 90890-06501
Center bolt 5: 90890-06504
3. Remove the propeller shaft assembly.
Disassembling the propeller shaft
assembly
1. Remove the spring 1, and then remove
the cross pin 2, dog clutch 3, slider,
and shift plunger.
6C13G11

Propeller shaft housing (FT50, FT60)

Disassembling the propeller shaft
housing
1. Remove the reverse gear and thrust
washer.
Bearing separator 1: 90890-06534
Stopper guide plate 2: 90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller assembly 4:
90890-06535
1
2
3
4
5
6
7
8
9
6-34