Coolant Level Check - Husqvarna TC 449 2011 I.E. Workshop Manual

8
1
2
Workshop Manual Ed. 03-2012
SETTINGS AND ADJUSTMENTS
TC 449 2011/2012 I.E.
TE 449 - 511 2011/2012 I.E.
TXC 449 - 511 2011/2012 I.E.
SMR 449 2011 I.E.
SMR 511 2011/2012 I.E.
- reassembly is a reverse of removal;
- undo cap (7) and remove cartridge filter (8);
(on reassembly, tighten plug (7) to a torque of 15 Nm / 1.5 Kgm / 11.6 ft/lb)
7
- replace filter (8), lubricate O-ring (9), and screw cap (7);
- once filter has been replaced, refit oil drainage plug (2), and pour the recom-
mended quantity of oil.
9 7
H006141

Coolant level check

Check level (1) inside left radiator, with the engine cold and the vehicle in vertical
position. The coolant should be approximately 10 mm (0.4 in) above the cells.
The radiator cap (2) features two locking positions, the first one is for prior dis-
charge of pressure from the cooling system.
H09072
H006142
Start the engine to allow the oil to reach all the points of the engine
and check the level as described in the relevant paragraph.
Avoid removing radiator cap (2) when engine is hot, as coolant may
spout out and cause scalding.
Difficulties may arise in eliminating coolant from painted surfaces.
If this occurs, wash off with water.
D.14