Table of Contents
Advertisement
Eject
(EJECT)
Push this button to stop and eject the tape.
Ignition Key-OFF Eject: The cassette being played will automatically
eject when the ignition or the unit is turned off.
NOTE: When one side of the tape ends, "Auto-Reverse" will
automatically begin playing the other side, therefore, you must push
the eject button to stop or remove the tape.
CLEAN Indicator Light
After 50 hours of cassette tape play, the light conies on as a reminder
to clean the tape heads. If the light comes on and the tape heads were
not cleaned at the recommended 30 hours of usage (see maintenance
section below), they should be cleaned immediately. To reset, push
and hold the indicator with a pointed instrument such as a ball-point
pen until the light goes off (about 3 seconds).
Defective Tape Eject
The tape player includes a protection mechanism to automatically
eject defective tapes (warped housing, loose label, faulty tape
movement) immediately upon insertion. If a tape malfunctions while
in play, the tape direction will change back and forth and then eject
the cassette. Tapes ejected before play should be considered faulty
and discarded; tapes ejected during play may only be unevenly wound
and could be reusable if fully rewound, manually, outside the player.
NOTE: The tape player may repeat the loading and unloading
motion several times in an effort to eject a faulty tape. During this
process the tape will either eject fully or rise to the loading level and
have to be pulled out manually. In either case, discard the tape; reuse
may damage the tape player.
Advertisement
Table of Contents
