Assigning A Site Address; Termination - GE Interlogix KTD-125 User Manual

Programming
7.1 A
SSIGNING A
CAUTION:
Make sure the receiver is in normal operating mode before
changing DIP switches 1 through 9 for site addressing.
To assign a site address perform the following.
Note: You can assign a site address while the unit has power.
1)
Confirm that DIP switch 10 is in the off position or normal mode.
2)
Determine which DIP switch values combine to equal the desired
site number. (See Appendix D: Assigning DIP Switch Values.)
3)
Set the DIP switches that correspond to those values to ON.
7.2 T
ERMINATION
If the RS422 cable does not loop out of the receiver to another unit, set
DIP switches 11 and 12 to ON to terminate.
32
KTD-125/127 PTZ Receivers User Manual
S A
ITE DDRESS
1040823A / June 2003