Makita BO3710 Instruction Manual page 6

While pulling abrasive paper to maintain the proper
tension, insert and secure the other end of abrasive
paper between another clamper and the pad and return
the paper clamp lever to the original position.
Place the punch plate (optional accessory) over the
paper so that the guide of the punch plate is flush with
the sides of the base. Then press the punch plate to
make holes in the paper.
To remove the paper, release the clamper as stated above.
For hook-and-loop type of abrasive paper with
pre-punched holes (optional accessory):
CAUTION:
Always use hook-and-loop type of abrasive papers.
•
Never use pressure-sensitive abrasive paper.
2
1
010218
Remove the pad for the conventional type of abrasive paper
from the tool with a screwdriver. Install the pad for the
hook-and-loop type of abrasive paper (optional accessory)
on the tool. Tighten the screws firmly to secure the pad.
1
2
010217
Remove all dirt or foreign matter from the pad. Attach the
paper to the pad, aligning the holes in the paper with
those in the pad.
1
010225
CAUTION:
When removing the pad, O ring may come out of
•
the tool. When this occurs, return the O ring to the
original position and then install the pad.
1. Screwdriver
2. Screw
1. Abrasive paper
2. Pad
1. O-ring
6
Dust bag (optional accessory)
1
010219
Attach the dust bag onto the dust spout. The dust spout
is tapered. When attaching the dust bag, push it onto the
dust spout firmly as far as it will go to prevent it from
coming off during operation.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Installing filter (Optional accessory)
009094
Make sure that the logo on the cardboard lip and the logo on
the dust box are on the same side, then install the filter by
fitting the cardboard lip in the groove of each holding tab.
009095
Make sure that the logo on the cardboard lip and the logo on
the dust nozzle are on the same side, then install the dust
nozzle on the dust box. Removing dust box and filter.
2
1
009092
Remove the dust nozzle by pushing the two latches.
1. Dust spout
2. Dust bag
2
1. Holding tab
1
1. Dust box
2. Dust nozzle
1
2
1. Latch
2. Dust nozzle