Bleeding The Hydraulic Brake System - Yamaha YP250R 2005 Service Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM

È
1
É
2
3 - 36
EAS01350
BLEEDING THE HYDRAULIC BRAKE
SYSTEM
WARNING
Bleed the hydraulic brake system when-
ever:
• the system is disassembled.
• a brake hose is loosened, disconnected
or replaced.
• the brake fluid level is very low.
• brake operation is faulty.
NOTE:
NOTE:
• Be careful not to spill any brake fluid or allow
the brake master cylinder reservoir to over-
flow.
• When bleeding the hydraulic brake system,
make sure there is always enough brake
fluid before applying the brake. Ignoring this
precaution could allow air to enter the
hydraulic brake system, considerably length-
ening the bleeding procedure.
• If bleeding is difficult, it may be necessary to
let the brake fluid settle for a few hours.
Repeat the bleeding procedure when the tiny
bubbles in the hose have disappeared.
1. Bleed:
• hydraulic brake system
M MMM M MMM M M MMM M
a. Fill the brake master cylinder reservoir to
the proper level with the recommended
brake fluid.
b. Install the brake master cylinder reservoir
diaphragm.
c. Connect a clear plastic hose 1 tightly to the
bleed screw 2.
È Front brake caliper
É Rear brake caliper
d. Place the other end of the hose into a con-
tainer.
e. Slowly apply the brake several times.
f. Fully squeeze the brake lever and hold it in
position.
CHK
ADJ
M MMM M M MMM M M MMM M MMM