Table of Contents
Advertisement
Installation and Setup Guide
FIELD
TITLE and DATA ENTRIES
Burglary Dialer Delay
*50
0 = no dial delay
1 = 15 seconds
2 = 30 seconds
3 = 45 seconds
Common Partition Primary Subs.
*51
Acct. No.
Enter digits 0–9; # + 11 for B, # + 12 for C,
# + 13 for D, # + 14 for E, # + 15 for F.
Common Partition Secondary Subs.
*52
Acct. No.
Enter digits 0–9; # + 11 for B, # + 12 for C, # +
13 for D, # + 14 for E, # + 15 for F.
SESCOA/Radionics Select
*53
0 = Radionics (0-9, B-F reporting)
1 = SESCOA (0-9 only reporting)
Dynamic Signaling Delay
*54
0 = disabled (both signals sent)
1–15 = entry times a 15-second delay.
e.g., 1 = 15 seconds, 2 = 30 seconds, etc.
Dynamic Signaling Priority
*55
0 = Primary dialer first;
1 = ECP Contact ID output first.
4-6
EXPLANATION
Provides delay of "BURGLARY ALARM" report to
the central station, which allows time for the
subscriber to avoid a false alarm transmission. This
delay does not apply to zone type 24 alarms (silent
burglary) or to 24-hour zone types 6, 7, and 8 (silent
panic, audible alarm, auxiliary alarm), which are
always sent as soon as they occur.
Enter up to 10 digits, depending on the report
format selected in field *48.
Enter up to 10 digits, depending on the report
format selected in field *48.
Select SESCOA or Radionics format.
Select 0 for all other formats.
Intended for use with ECP Contact ID Output
reporting via ACM.
This field lets you select the time the panel should
wait for acknowledgment from the first reporting
destination (see ∗55) before it attempts to send a
message to the second destination. Delays can be
selected from 0 to 225 seconds, in 15-second
increments. This delay is per message. If "0" is
entered in this field, the control panel will send
redundant reports to both Primary Dialer and ECP
output.
Intended for use with Alternative Communication
Media reporting.
You must also enable field ∗29, ECP Contact ID
Output for ACM.
Select the initial reporting destination for messages
as follows:
Primary Dialer First selected (0):
• If acknowledged before delay expires (see ∗54),
then message will not be sent to ECP output.
• If not acknowledged before delay expires, then
message is sent to both the Primary Phone No.
and ECP output.
ECP Contact ID Output First selected (1):
• If acknowledged before delay expires, then
message will not be sent to the primary dialer.
• If not acknowledged before delay expires, then
message is sent to both the Primary Phone No.
and ECP Contact ID output.
Advertisement
Table of Contents
