Table of Contents
Advertisement
Installation and Setup Guide
Powerline Carrier Devices
1. Install up to 4 powerline carrier devices (if no
relays are used) according to the instructions
included with each.
2. Connect the Powerline Interface Modulator
(XM10E) to the trigger pins as shown below
(use PSC04 for 110VAC 60Hz installations
such as in Canada, use XM10E for 220VAC
50Hz installations).
3. Use Programming Mode to enter the device
house ID in data field*27, and enter the unit
code using *79 Output Device menu Mode.
8-PIN TRIGGER CONNECTOR
1
3
4
5
6
2-16
7
8
SA4120XM-1 CABLE
(PART OF 4120TR)
SYNC
COM
DATA
PSC04/XM10E Powerline Interface Connections
Notes
• When using Powerline Carrier devices, you
must use a Powerline Carrier Device
Modulator. It supplies signals from the
control panel through the premises AC
mains wiring to the Powerline Carrier
devices (which are plugged into AC outlets).
You can then make devices that are plugged
into Powerline Carrier devices perform
various functions in response to commands
you enter at the security system keypads.
PSC04 (CANADA) / XM10E
POWERLINE INTERFACE
MODULATOR
BLK
MODULAR PHONE CORD (not supplied)
1 - BLACK
GRN
2 - RED
3 - GREEN
4 - YELLOW
RED
YEL
1 2 3 4
00-trigcon-010-V0
Advertisement
Table of Contents
