Rear Fork Disassembly; Rear Fork Inspection; Play In The Break Pedal; Measuring Pivot Rubber Bushing - Honda C50 Shop Manual

o e)
er connecting the rear brake, adjust the brake
pedal p loy to 2-3cm 10.787-1.181 inl.
(Fig. 4-39)
.7
REAR FORK
The rear fo rk is of a swing arm type which pivots
on th e rear fork pivot bolt. The rear end of the fork
is supported by the frame through th e rear cushions.
a. Disassembly"'
11 ) Remove th e rear wh eel in accordance with
section 4.5 1a.
1 2) Remove the drive chain upper half, lower half
and final drive flange in accordance with secti on
4.8a.
(3) R emove th e 1 Omm nut fixing the rear cushion at
the lower end.
141 Remove the rear fo rk pivot bolt by loosening
the rear fork pivot nut, then the rear fork con
be removed from the frame. (Fig. 4-40)
b. Inspection
{1)
Dama ged o r worn drive chain case gasket should
be replaced.
12) Check the rear fo rk pivot rubber bushing .
(Fig. 4- 41)
Standard va lu e-+
C65, C65M O.D 23 mm
C50, C50M 10.90551
S50 O .D 25 mm
S65
(0.9842)
I.D 12. 1mm
10.4764)
+0.05
10.0020
+ 0.03 10.0012
+ 0.05 10.0020
+ 0.03 10.0012
+0.2 10.0079
- 0 (0
in)
in)
in)
in)
in)
in)
3 T-ha ndl e
scre wdriver
Figure 4-. 3 8, Installing stand spring
Figure 4- 39. Ploy in the brok e pedal
Rear fork
Figure 4- 40. Removing rear fork
Rear fork pivot rubber bushing
Rear for k
I
Figure 4- 41 . Measuring pivot rubb<;lr bush in9