Rear Wheel Construction; Rear Wheel Disassembly; Rear Wheel Inspection; Measuring Brake Lining - Honda C50 Shop Manual

.5 REAR WHEE
4.5
EEL
EEL CONSTRUCT!
: - · :::' ·o the front wheel, I e rear eel consist
::: ::as; alumi num alloy rear eel
b
incorporating
=
oeorings, and a brake pa el.
A
tire size
.25- 17- 4 PR is used w ith the rim made of rolled steel
sheet.
A
specia lly designed tread pattern is used on
th e rear tire fo r better traction and to prevent side-
slipping.
In addition, the rear wheel hub and the final driven
flange have been made into an integral component
for li ghtness.
a. Disassembly
Ill Remove t he muffler.
The muffler need not be removed fo r S50 and S65.
121 Re move t he d rive chai n case lower half and dis-
connect t he chain.
1 31 Remove the brake ad justing nut and separate the
brake rod f rom the rear brake arm.
141 Separate the rear brake torque link from the
brake panel.
151 Remove t he rear whee l ax le by r emoving the axle
nut and th en th e rear wheel may be removed .
(Fig. 4- 27)
161 The b rake shoe and the rear wheel is dis-
assembled in the same manner as the front wheel.
b . Inspection
11) The rim runout and eccentricity is checked in the
same manner as t he f ront whee l and to the same
standard.
121 C heck the rear axle diameter fo r wear and bend.
(Fig. 4- 28)
Standard Value Repair Limit
Axle
11.957- 11 .984
Diameter
1.4707 ~ .4720 i n.)
Bend
0.2 !.008 in.)
Repair or replace
if
over 0.5 1 0 .020 in.l
131 The b rake drum ID and the brake shoe OD is
checked in t he same manner as th e f ront wheel
and to the same standard.
141 Check the brake lining for wear. (Fig. 4- 29)
St andard va lu e->3.5 10. 1378 in)
Serviceab le li mit-Rep lace if under 1.5 10.05901
1 51 Check spokes for looseness, r etighten if necessary.
(Note)
The spoke should be retightened to the same
te nsion as the othe r spokes.
Figure 4- 27. emoving rear wheel
Figure 4- 28. M easuring bend in rear axle
Figure 4- 29.
eosuring broke lining
57
_j