Installing A Sodimm - Cisco 12000 Series Replacement Instructions Manual

Figure 14
Immediately place the SODIMM in an antistatic bag to protect it from ESD damage.
Step 7

Installing a SODIMM

To install a SODIMM, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 Place the line card on an antistatic mat so that the faceplate is nearest to you.
Step 3 Check the retaining clip to make sure it has not been damaged or bent.
Figure 15
If the retaining clip is damaged, do not use it. This can damage the SODIMM socket.
Caution
The retaining clip is not used with all ISE, Engine 4, and Engine 4+ line cards. If your SODIMM socket
Note
does not include the retaining clip; there is no problem. Simply ignore any instructions that refer to the
clip.
78-4338-16
Removing a SODIMM
a
SODIMM Socket Retaining Clip
Removing and Installing Line Card Memory
45 º
Cisco 12000 Series Router Memory Replacement Instructions
b
29