Da Main And Standby Power Supply Cables; Npm Power Supply Cable - Honeywell X-618 Installation Manual

Figure 25 Schematic Diagram of the DCS Standby Power Supply Cable Connection

DA Main and Standby Power Supply Cables

Connecting the Main Power Supply Cable
1. Strip off the wire jacket of one end of the AC power supply cable by 20mm and connect the
cable to the main power supply wiring terminal, as shown in Figure 24.
2. Tighten the screws to prevent the power supply cable from coming loose, and cover the power
supply interface set.
3. Insert the wiring terminal of the installed power supply cable into the main power supply input
port of the DA, and tighten the screws at both ends.
4. Insert the other end of the power supply cable into the main power supply equipment.
Connecting the Standby Power Supply Cable
1. Strip off the wire jacket of one end of the prepared standby power supply cable by 20mm and
connect the cable to the standby power supply wiring terminal, as shown in Figure 24. The
installation procedure is similar to that of installing the main power supply cable.
2. Tighten the screws to prevent the power supply cable from coming loose, and cover the power
supply interface set.
3. Insert the wiring terminal of the installed power supply cable into the standby power supply
input port of the DA, and tighten the screws at both ends.
4. Insert the other end of the standby power supply cable into the standby power supply
equipment, such as the Uninterrupted Power Supply (UPS).

NPM Power Supply Cable

Insert one end of the power supply adapter into the NPM power supply input port, and connect the
other end of the power supply adapter cable to the power supply equipment, as shown in Figure 26.
19