Honeywell X-618 Installation Manual page 18

2. Connecting the DA audio output to the DCS
a. Strip one end of the prepared audio output cable jacket by 10mm, and feed the cable
through the DCS protective cover of the terminal, as shown in Figure 12.
Figure 12 Schematic Diagram of a Feeding the Audio Output Cable Through the
Protective Terminal Cover
b. Take the end of the cable that was fed through the protective cover of the DCS
terminal
tail seating 5.08mm), and tighten the screws. Refer to Figure 13.
Figure 13 Connecting the Audio Output Cable to the Power Amplifier Input Wiring
Terminal
c. Feed the other end of the audio output cable through the protective cover of the power
amplifier. Refer to Figure 12.
d. Connect the end of the cable that was fed through the protective cover of the power
amplifier to the power amplifier input wiring terminal (4P green phoenix tail seating
5.08mm), and tighten the screws. Refer to Figure 13.
e. Insert the power amplifier audio output wiring terminal of the installed audio output cable
into the DA audio output port, as shown in Figure 14.
12
connect the cable to the power amplifier output wiring terminal (7P green phoenix
wiring