Honda 08B06-SDA-100 Installation Instructions Manual page 8

In-Dash CD Player
• Secure the connectors to the rear of the in-
dash CD player with one wire tie from in the in-
dash CD player kit.
IN-DASH CD
PLAYER
IN-DASH CD
CHANGER
CONNECTOR
WIRE TIE
(Supplied with
player kit)
15. To protect the center panel, attach the masking
tape to the panel in the area shown.
8 of 9
BUS CABLE
(Sold
separately)
BUS CABLE
CONNECTOR
CENTER
PANEL
MASKING
TAPE
2506010T
16. Plug the BUS cable connector into the vehicle
connector.
With Navigation System
• Wrap the plugged connectors with one EPT
sealer.
BUS CABLE
CONNECTOR
(With
navigation
system.)
LEFT PLAYER
BRACKET
2306110T
6 mm
FLANGE
NUT
17. Insert the studs of the left and right player
subbrackets and player base-bracket into the
holes in the left and right player brackets, then
install one 6 mm flange nut on the end of each
stud.
18. Attach two grommet screws to the player panel in
the square holes shown.
GROMMET
SCREW
AII 24379 (0208)
VEHICLE
CONNECTOR
VEHICLE CONNECTOR
(With navigation
(Without navigation
system)
system)
RIGHT
PLAYER
BRACKET
RIGHT PLAYER
PLAYER BASE-
SUBBRACKET
BRACKET
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
BUS CABLE
CONNECTOR
(Without
navigation
system)
LEFT PLAYER
SUBBRACKET
2306121T
PLAYER
PANEL
2306131T