D-Link DWC-1000 User Manual page 213

Wireless Controller
3.
Chose the From Zone to be the source of originating traffic: either the secure LAN, public
DMZ, or insecure Option. For an inbound rule Option should be selected as the From
Zone.
4.
Choose the To Zone to be the destination of traffic covered by this rule. If the From Zone
is the Option, the To Zone can be the public DMZ or secure LAN. Similarly if the From
Zone is the LAN, then the To Zone can be the public DMZ or insecure Option.
5.
Parameters that define the firewall rule include the following:






Service: ANY means all traffic is affected by this rule. For a specific
service the drop down list has common services, or you can select a
custom defined service.
Action & Schedule: Select one of the 4 actions that this rule defines:
BLOCK always, ALLOW always, BLOCK by schedule otherwise
ALLOW, or ALLOW by schedule otherwise BLOCK. A schedule must be
preconfigured in order for it to be available in the dropdown list to assign
to this rule.
Source & Destination users: For each relevant category, select the users
to which the rule applies:

Any (all users)

Single Address (enter an IP address)

Address Range (enter the appropriate IP address range)
Log: traffic that is filtered by this rule can be logged; this requires
configuring the controller's logging feature separately.
QoS Priority: Outbound rules (where To Zone = insecure Option only)
can have the traffic marked with a QoS priority tag. Select a priority
level:

Normal-Service: ToS=0 (lowest QoS)

Minimize-Cost: ToS=1

Maximize-Reliability: ToS=2

Maximize-Throughput: ToS=4
Minimize-Delay: ToS=8 (highest QoS)
212
User Manual