Honda AQUATRAX R-12X 2005 Owner's Manual page 136

Engine Oil & Filter
3. Stop the flushing.
NOTICE
Avoid running the engine without water flow
for more than 15 seconds to prevent severe
engine and exhaust system damage.
4. Stop the engine and wait a few minutes.
5. Remove the seat (page
This procedure continues with Step 6 on
129.
128
Servicing Your Honda
117).
page
To check the oil level on calm water
1. Start the engine.
2. Warm up the engine at approximately 4,000
rpm for 5 minutes.
If the air temperature is below 10°C (50°F),
let the engine idle for an additional 5
minutes (a total of 10 minutes).
3. Let the engine idle for a minute.
4. Stop the engine and get off your PWC.
5. Remove the seat (page 117).