Honda BIG RED 2009 Owner's Manual page 105

Engine Oil & Filter
11. Remove the oil filter bolt and oil filter cover.
Let the remaining oil drain out.
12. Remove the oil filter from the oil filter cover.
13. Remove the spring and washer. Do not discard the washer with the
old oil filter.
14. Check the O-rings are in good condition, then insert a new oil filter
to the oil filter cover.
Use only the Honda Genuine oil filter or a filter of equivalent quality
specified for your model. Using the wrong Honda filter or a non-
Honda filter which is not of equivalent quality may cause engine
damage.
15. Install the oil filter cover and tighten the oil filter bolt. Make sure the
oil filter bolt is tightened securely to the specified torque.
Oil filter bolt torque:
13 lbf·ft (18 N·m , 1.8 kgf·m)
Improper installation of the oil filter can cause serious engine damage.
oil filter
washer
spring
oil filter cover
oil filter bolt
96 Servicing Your Honda
oil filter cover
o-rings
oil filter bolt