7. Install a new oil filter with the "OUT-
SIDE" mark facing out.
8. Install the spring into the oil filter cover,
and then install a new gasket and oil
filter cover by tightening the oil filter
cover bolts.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft).
9. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 24 N·m (2.4 kgf·m, 18 lbf·ft).
10. Fill the crankcase with the recommended
oil (
P. 45) and install the oil fill cap.
2
Required oil
When changing oil & engine oil
filter:
1.5 litres (1.6 US qt, 1.3 Imp qt)
When changing oil only:
1.4 litres (1.5 US qt, 1.2 Imp qt)
Engine Oil
11. Check the oil level.
12. Check that there are no oil leaks.
NOTICE
Improper installation of the oil filter can result in serious
damage to the engine.
Rubber seal
Oil filter cover
Oil filter cover bolts
http://mototh.com
u
Changing Engine Oil & Filter
P. 56
2
Spring
Oil filter
"OUT-SIDE" mark
Gasket
59