Advertisement
4.
Holding the detector vertically, insert it into the charging cradle.
Ensure the connector holes at the bottom of the detector align
over the black prongs on the retaining base. Refer to Figure 6.
5.
Push the detector down, angle it towards the back of the charger,
and release. Refer to Figure 7. The detector sits securely if
inserted correctly. Refer to Figure 4.
Figure 4. Inserting the Detector into the Charger
The charger emits one beep and the LED lights red to indicate the
battery is charging.
6.
Allow the battery to fully charge (approximately 3.5 hours).
The charging LED changes to green when charging is complete.
When the detector is removed from the charger, the LED
deactivates.
Remove/Replace the Battery Pack
To remove/replace the battery pack, refer to Figure 5 and complete the
following:
1.
Deactivate the detector.
2.
Open the latch on the bottom of the detector.
3.
Remove the battery pack by lifting the bottom of the pack away
from the detector.
4.
Insert the new battery pack. Close and press the latch until the
release tabs click.
Figure 5. Removing the Battery Pack
Charging the Battery Pack without the Detector
To charge the battery pack separately, complete the following:
1.
Insert the power cord into the charger port. Refer to Figure 3.
2.
Plug the power cord into a Vac outlet.
The charger performs a self-test. The charger LED lights red then
green during the test. When the self-test is complete, the LED
deactivates.
3.
Deactivate the detector and remove the battery pack. If required,
refer to
Remove/Replace the Battery
Pack.
4.
Holding the battery pack vertically, insert it into the charging cradle.
Ensure the connector holes at the bottom of the battery pack align
over the black prongs on the retaining base. Refer to Figure 6.
Figure 6. Charging the Battery Pack without the Detector (Front)
Advertisement
