Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Honeywell COB01
Summary of Contents for Honeywell COB01
- Page 1 Charge-Only Base COB01 Installation Guide COB01-INST Rev C 10/13...
-
Page 2: Installation
Introduction Honeywell’s Charge-Only Base can fully charge a Xenon™ 1902 or Hyperion 1302g scanner in less than eight hours (typically 4.5 hours), maximizing uptime in any application. Note: When a scanner is placed into the Charge-Only Base, the battery will charge. Please note that the Charge-Only Base will not facilitate communication with the host system or other scanners. -
Page 3: Operation And Indicators
Operation and Indicators 1. Place a scanner into the cradle to charge. 2. When a scanner is inserted, the green LED flashes according to the chart below. If the Green LED does not appear, check to make sure the scanner is seated completely in the charger with the battery contacts touching the contacts on the charger. - Page 4 Shut Down Scanner in Base: Shuts down the scanner while in the base. (This results in the scanner charging at the fastest rate.) Scanning in Base On Scanning in Base Off Shut Down Scanner in Base...
- Page 5 COB01 Product Specifications Dimensions (Typical): Height 3.2 inches (8.128cm) Length 5.19 inches (13.183cm) Width 3.98 inches (10.109cm) Weight 6.3 oz (179g) Voltage 4.5 to 5.5 volts Current Charge Time 5 hours Temperature Ranges: Operating 41° F to +104° F (5° C to +40° C) Storage -40°...
-
Page 6: Required Safety Labels
Required Safety Labels Item Number, Compliance Serial Label location Number Revision Information location Product Agency Compliance FCC Part 15 Subpart B Class B This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. - Page 7 The user may find the following booklet helpful: “Something About Interference.” This is available at FCC local regional offices. Honeywell is not responsible for any radio or television interference caused by unauthorized modifications of this equipment or the substitution or attachment of connecting cables and equipment other than those specified by Honeywell.
- Page 8 Nijverheidsweg 9-13 5627 BT Eindhoven The Netherlands Honeywell shall not be liable for use of our product with equip- ment (i.e., power supplies, personal computers, etc.) that is not CE marked and does not comply with the Low Voltage Directive.
-
Page 9: Technical Assistance
Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. The information in this publication does... - Page 10 This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII. 2010-2013 Honeywell International Inc. All rights reserved. Web Address: www.honeywellaidc.com...