Restore And Reboot - NETGEAR CWGE111 User Manual

Restore and Reboot

When this option is clicked, factory default settings are restored and the unit restarts.
Restore to Factory Default
There are two ways to restore the 802.11g WiFi Receiver to default settings.
1. Click the Restore and Reboot button.
If you can access the web admin interface, go to the CPE Setup page, and click the
Restore and Reboot button. When this button is clicked, the factory default settings to
restored and the unit automatically restarts.
2. Press the Reset Button on the unit
If you cannot access the admin interface, you can power up the unit and wait for about 3
minutes. Then, using a pin or paperclip, press the Reset Button at the top of the unit and
hold it for 5 seconds. The unit restores the settings to factory default and automatically
reboot the unit.
Reboot the CWGE111
1. Click the Reboot button from the admin interface.
The 802.11g WiFi Receiver will automatically restart.
24 | Chapter 2: Advanced Configuration
CWGE111 802.11g WiFi Receiver User Manual