NETGEAR CWGE111 User Manual page 17

CWGE111 802.11g WiFi Receiver User Manual
b. Static WEP Key: You should enter an encryption key in the Encryption Key field.
c. 802.1x with dynamic WEP key: You do not need to use 802.1x unless instructed to
do so by your ISP.
d. WPA/WPA2-Enterprise: You do not need to use WPA/WPA2-Enterprise unless
instructed to do so by your ISP.
e. WPA/WPA2-Personal: You should enter an encryption key in the Encryption Key
field.
4. Encryption Key
The encryption key must be at least 8 characters.
a. Hide/Show Encryption Key: this allows you to show or hide the actual value of the
password. (e.g., ***** vs. 12345)
5. Preferred AP
a. MAC: The MAC address of a preferred access point (AP) can be entered here. When
the preferred access point is found and its signal strength is higher than the Min
Signal Strength, it will connect to this preferred access point, even when other access
points are found having higher signal strength or the same SSID.
b. Minimum Signal Strength:
c. APs with matching SSID:
6. Click SAVE at the bottom of the screen to apply the settings.
Chapter 2: Advanced Configuration | 17