How To Restrict Wireless Access By Mac Address - NETGEAR RangeMax WPN824 Reference Manual

3. Click Apply to save your settings.
Note: If you use a wireless computer to configure WPA-PSK or WPA2-PSK settings, you
will be disconnected when you click Apply. You must then either configure your
wireless adapter to match the wireless router WPA settings or access the wireless
router from a wired computer to make any further changes.

How to Restrict Wireless Access by MAC Address

To restrict access based on MAC addresses, follow these steps:
1. Log in to the WPN824 firewall at its default LAN address of
its default user name of admin and default password of password, or using whatever LAN
address and password you have set up.
Note: When configuring the firewall from a wireless computer whose MAC address
is not in the Trusted PC list, if you select Turn Access Control On, you will
lose your wireless connection when you click on Apply. You must then access
the wireless router from a wired computer or from a wireless computer which
is on the access control list to make any further changes.
2. Click Wireless Settings in the Advanced section of the main menu of the WPN824 firewall.
3. From the Wireless Settings menu, click Setup Access List to display the Wireless Access
menu shown below.
Figure 4-8
Wireless Configuration
Reference Manual for the RangeMax Wireless Router WPN824
v1.0, November 2005
http://www.routerlogin.net with
4-15