Table of Contents
Advertisement
30
en | Final assembly and Sunshield installation
8
Final assembly and Sunshield installation
8.1
Final assembly
1.
2.
3.
4.
5.
6.
8.2
Sunshield installation
1.
2.
3.
4.
2014.05 | 4.0 | F.01U.167.418
Use the hole plugs provided to plug any unused holes in the rear cap.
Replace the camera and bracket back into the housing.
Slide the camera/lens tray into the slot near the clasp side of the housing. Refer to
Camera/Lens installation, page 17.
Install screws into the appropriate holes.
Close the cover and secure the latches.
Optional tamper-resistant screws are provided with the housing. If desired, secure the
latch using these three screws and the provided tamper-resistant wrench.
Loosen the two screws (M4 x 10) on the top of the housing.
Slide the sunshield to the desired position. It has a range of 50 mm (2 in).
Tighten the screws to lock the sunshade into position.
If the sunshield is removed or not installed, plug the two screw holes with the hole plugs
supplied with the housing hardware kit.
Operation Manual
UHI/UHO Series Camera Housing
Bosch Security Systems, Inc.
Advertisement
Table of Contents
