Bosch MIC-67SUNSHLD Quick Installation Manual

1 |
Install the MIC7000 Sunshield
Parts List
Two (2) Sunshield shells "A"
One (1) Sunshield shell "B" (without vents)
Four (4) M4 x 8 socket head Torx screws
Two (2) M4 x 14 socket head Torx screws
Four (4) M4 flat washers
One (1) Quick Installation Guide
Additional Tools Required
1 Phillips-head screwdriver, #2, to remove
factory-installed plastic screws from the
camera head
1 Torx driver, T20, for M4 Torx head screws
5 |
B
A
A A
4. Align the sunshield shells so that the pins
slide into the bolt heads on the faceplate.
When attaching to a MIC with an illuminator, use
shell "B" without vents.
2 |
Notice!
If your MIC camera will be canted, in-
stall the sunshield first.
If your MIC camera will have both illu-
minator and sunshield accessories, in-
stall the illuminator first.
Extreme low temperature models do
not support a sunshield.
24 VAC
1. Mount the camera. Apply power. Connect us-
ing a web browser or VMS.
6 |
A A
M4 x 8
2.2 N m
(19.5 in. lb)
M4 x 8
T20 Torx
2.2 N m
(19.5 in. lb)
5. Ensure that the sunshield mounting holes
align with the holes in the rear of the camera
head. Install 4 screws and washers.
3 |
2. Operate the tilt to near the upper limit.
7 |
A B
M4 x 14
2.2 N m
M4 x 8
(19.5 in. lb)
2.2 N m
T20 Torx
(19.5 in. lb)
6. Use the longer screws for shell "B".
4 |
#2 Phillips
3. Remove and discard 4 screws.
8 |
3.5 mm ( ≈ 1/8")
7. If the rear gap is not parallel, rework to en-
sure that the pins are seated properly in the bolt
heads on the faceplate.