Makita BO6030 Instruction Manual page 8

ASSEMBLY
Front grip
Install the front grip on the tool
so
that
its
protrusions fit into the matching notches in
the front of the tool. Secure the front grip
using a screwdriver to tighten the screw
through the hole in the front grip.
I
r
Installing or removing abrasive disc
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
Always use hook-and-loop system abrasive discs. Never use pressure-sensitive abrasive
the abrasive disc.
discs.
To install the abrasive disc, first remove all
dirt or foreign matter from the pad. Then
attach the abrasive disc to the pad, using
the hook-and-loop system of the abrasive
disc and the pad. Be careful to align the
holes in the abrasive disc with those in the
pad.
To remove the disc from the pad, just pull
up from its edge.
Changing pad
Makita offers an extensive range of op-
tional super soft and standard equipped
soft pads. Remove the screw counterclock-
wise from the center of the base with
a hex wrench. After changing the pad,
tighten the screw clockwise to secure the
pad.
I
I
Hex wrench
8