Operation - Makita BO6030 Instruction Manual

OPERATION
Sanding operation
Turn the tool on and wait until it attains full
speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with
the workpiece and apply slight pressure on
the tool.
CAUTION:
Never switch on the tool when it is in contact with the workpiece surface, causing an
Never run the tool without the abrasive disc. You may seriously damage the pad.
Never force the tool. Excessive pressure may decrease the sanding efficiency, damage
injury to operator.
the abrasive disc or shorten tool life.
Polishing operation
CAUTION:
Use only a Makita genuine sponge pad, felt pad or wool pad (optional accessories).
Always operate the tool at low speed to prevent work surfaces from heating abnormally.
Never force the tool. Excessive pressure may decrease the polishing efficiency and
cause motor overload, resulting in tool malfunction.
Applying wax
Use an optional sponge pad. Apply wax to
the sponge pad or work surface. Run the
tool at low speed to smooth out wax.
NOTE:
First, wax a not conspicuous portion of the work surface to make sure that the tool will
not scratch the surface or result in uneven waxing.
11