Softune Workbench Debugger - Fujitsu SK-91460T-144PMC-GPIO User Manual

7. Select the active configuration STANDALONE. In this configuration the application is
linked for the available memory on flash-device, e.g. MB91F467T.
8. Use "Make", or "Build" to compile and link the project for available memory on flash-
device. The generated output files can be found in the sub-folder STANDALONE of
the project folder. The *.mhx file (Motorola S-Record) is located in the ABS sub-
folder.
9. Now, the application can be debugged, therefore, please have a look at the next
chapter. Or the generated *.mhx file (Motorola S-Record) can be programmed with
the flash programming utility into the internal flash. Please keep in mind, that
therefore the mode pins have to be set to "Internal ROM Mode Vector".

5.1 Softune Workbench Debugger

5.1.1 General Description
Whenever you have created a valid load module successfully, you can switch from the
development mode to the debugging mode of Softune Workbench.
Basically, there are 3 types of debugging systems supported:
1. The software simulator: The simulator is part of the Softune Workbench and does
not require any target hardware. The simulator will cover the FR-core features,
but no peripheral functions. Therefore, you can use the simulator to verify
program flow, check for dynamic errors, look at the generated assembler code,
etc. .
2. The SWB Monitor Debugger: This debugger type requires an evaluation board
like the "SK-91F460T-144PMC" connected to one of the COM-ports of your PC.
Explanations in this manual refer to the SWB Monitor Debugger only. For further
information please see also the application note "SWB_monitor_debugger" The
Starterkit SK-91460T-144PMC-GPIO does NOT support debugging with Monitor
debugger.
3. The emulator debugger: The in-circuit emulator (ICE) is a system, which allows a
connection to any target system using a probe-cable. The appropriate system for
the MB91460 series is the MB2198-01 system. More information about this
system can be found on the Fujitsu website.
© Fujitsu Microelectronics Europe GmbH
SK-91460T-144PMC-GPIO User Guide
Chapter 5 Getting Started
Note:
Always check the memory map of the linker settings and ensure
that this memory map is suitable for the application and target
system in use. Additionally the *.mp1 file should be checked to
ensure correct settings.
Note:
The starter-kit is delivered with the mode pin settings for the
"External ROM Mode Vector", which allows to debug the
application with the pro-programmed SWB Monitor Debugger.
If the application should be programmed into the internal flash, the
mode pins have to be switched to the "Internal ROM Mode
Vector".
- 33 - FMEMCU-UG-910074-11